Benefon TWIG INBOX Instrukcja Użytkownika Pobierz pdf (Strona 106)

MPTP | MPTP commands 106

For the format of most of the persistent setting reports cf. 4.6. Command is of course replaced with !PSR.

4.9. Reset terminal request (?RST)

CC → MTT

This command can be used to reset the terminal remotely. Resetting terminal means that it is switched off

and on again after awhile. The command can also be used to reset the device to factory defaults

Supported Benefon/TWIG instruments and SW versions: Send Receive

Twig Protector SW CG1P.01.001.0000

•

Reception

Upon receiving a reset terminal request command the terminal will power off and on again after few

minutes. This is done even if the terminal is connected to charger.

Depending on the authorization of the Control Centre which requested the action, the action may be

performed automatically or the request may be disregarded altogether. Cf. section 2.1.3 for more

information. If a parameter is included it may also change settings of the device or reset to factory settings.

Command format

Length: 6 characters

Command*

Action

4 1 8

?RST _ 0

*) cf. section 3.1 for description of this field.

The special fields of the command are as follows:

Field Description Range

Action Action to be performed after receiving the

message.

0: Power off and on again.

1: GPS Factory reset ( almanac,

ephemeris, location, time )

2: GPS Ephemeris reset

8-digits from the END of device IMEI

resets the device to software

default values

0..8

1 2 ... 101 102 103 104 105 106 107

Brak uwag

Benefon TWIG INBOX Instrukcja Użytkownika Strona 106